About jason.tollefsen

Recent comments

Title ↓	Date
"I am pulling the lever as hard as I...	29 Jan
"I also tried turning the impression...	28 Jan
Your C&P is Craftsman auto (just as the...	2 Jun
Yea, the inner race might look a little...	8 Mar
We just did some work using Manifesto's...	8 Jun
Those are Bar-Plates "Adjusto...	10 Mar
This should help, Here's a view of...	1 Feb
The set of screws up top you're talking...	6 Aug
Thanks Bob - Its a consequence of my...	25 Jun
Thanks - yours too. I didn't have a...	12 Mar
Sure, happy to share... you should have...	14 Dec
Sure - I should have mentioned that. I...	27 Jun
So I'll bite - I'll admit I haven't...	6 May
Sarahvw, Just came across this PDF...	3 Mar
Robert, I think our terminology...	5 Mar
Robert, I played with the throw-off...	3 Mar
Pammy, That’s good information...	5 Aug
Nicely done, Your experience sounds...	19 Nov
Matthew, I'm going through a similar...	9 Nov
Looks like you got your work cut out...	26 Jun
Katesy, "The further down the...	25 Mar
Jason, You mention a schematic - are...	26 Jun
Jason, I think I've replied to one...	4 Aug
I've seen some literature somewhere...	14 Nov
I'm pretty sure I've seen it mentioned...	22 Apr
I'll chime in on that "kicking yourself...	2 Apr
I'll be curious to see suggestions on...	12 Apr
I'd agree with both answers...	14 Apr
It looks like a Chandler & Price New...	29 Feb
If I were you I'd check the amount of...	30 Apr
I just re-did all the hoses on my press...	1 Nov
I just came across your previous post...	26 Mar
I don't know, you might want to start a...	1 Mar
I don't know much about the different...	21 Apr
I didn't see the width mentioned, but...	8 Mar
I caught on to this post a little too...	4 Mar
Hey Hugo, Found that reference to an...	16 Nov
Hey guys - I just found...	26 Jun
Hey Gunnar, I just went out and had...	23 Dec
Hey Ben, Follow the link in this...	6 Aug