About linegauge

image: linegauge's picture
Recent content
TitleUpdated
Aluminum and resalite furniture17 Apr 20
Anyone need a few Ludlows and a ton of mats?28 Feb 18
Schmidt Graphic Equipment, Inc.10 Nov 14
Dried and stubborn ink remover14 Mar 11
Watch the classified ads26 May 10
Furniture5 May 09
Backup plates?5 May 09
Recent comments
Title ↑Date
1. Back out both adjusting screws about...29 Jul
A 1/2 or 3/4 HP motor will definitely...6 Mar
AA die in Atlanta does laser...12 Nov
Aaron: Customers are actually looking...3 Oct
Acid based paper never gave much of a...12 Nov
Actually you have to remove the inker....29 Oct
Again I forgot to answer your question:...3 Oct
Are you sure that it is a 1959?? What...22 Sep
Are you talking about the impression...2 Mar
As a mechanic, the Miehle is a great...10 Nov
Attached to the big handle on the left...3 Oct
Boxcar Press has an excellent video on...15 Apr
Buying printing is like buying oats. If...12 Nov
Can't get them that I know of. If they...4 Jan
Can't see for sure, is the handle on...10 Apr
Careful with the wine or you will get...4 Nov
Check and see what type of joists are...21 May
Check out Rudow, the sucker people at...1 Jun
Check that there are no loose bearings...2 Jun
Check the information plate on the...3 Jun
Clean the painted areas with odorless...26 Oct
Contact Boxcar Press at...13 Apr
Depending on the slope, I install...13 Apr
Disconnect the motor from the hydraulic...4 Nov
Disconnect the oil pipe exiting the...27 May
Does the clutch "grab" when you engage...6 Jul
Email me and I will forward a series of...9 Dec
Email me. I am an independent service...19 Jan
Enough already. Alan is doing what he...17 Jun
Fabio: If you look closely at the...2 Oct
For the ink disk and any other place...26 Jun
Forgot: Don't worry about the air...10 Apr
Get the platen about 4" from the...23 Mar
Glad to know the translators are not...1 Nov
Grainger has motors that will match up....6 Mar
Have someone (electrical or...31 Oct
Have the machinist make a new shaft and...10 May
He sends the dies back to the die-maker...4 Jan
Hey Fabio, Got that monster up and...27 Sep
Hey Fabio, still at it? Replace the...20 Feb