Seattle area electrician

Looking for someone to take a look at the Marathon electric motor setup on my platen press. Any referrals would be appreciated. Thanks.

image: IMG_20160202_165245-2.jpg


image: IMG_20160202_165229.jpg


Log in to reply   1 reply so far

Hello again,
Say you can get a convertor for that but dollar wise just get yourself a single phase 1 hp electric motor. Run it on 220 preferably for you 10x15 or it will operate at 110/115. You’ll need to replace the switch & adjust the belt. Get an Electrician to wire that for you.