Category: Troubleshooting the press
Later topic: Stiff Throw-Off Lever on ARAB Press
Earlier topic: Fixing a Kelsey Star platen press - Advices...

Need a part machined for Vandercook Universal 3

My vandy went through a couple moves recently, while getting the shop set up again I sadly discovered a metal piece missing — it might be called the feed board support / spacer block.

I have the block for one side, trying to figure out how to get a block machined for the other side. I imagine it would be too much to hope to find a replacement.

image: PXL_20251214_183215170.jpg

PXL_20251214_183215170.jpg

image: PXL_20251214_183228394.jpg

PXL_20251214_183228394.jpg

Log in to reply   1 reply so far

  • ericm
  • on 15 Dec 25 (07:22)

I can make one, so, reach out if you can’t find one. I am in Milwaukee, Wis.