Category: Troubleshooting the press
Later topic: Rollers for 7X11 Clipper press
Earlier topic: C&P New series roller springs

Heidelberg Windmill -disassembling gripper GT1301

My GT1301 was deformed because of an accident,
so I need to buy a new one to replace it.
But I can`t remove it.

Came here to search for the issues that might someone had a same problem :
http://www.briarpress.org/44698

But I still can`t understand how the topic remove it,please show me the detail or steps to remove it.
Really appreicate for help!

image: side

side

image: close up

close up

image: gt1301

gt1301

image: front.jpg

front.jpg

Log in to reply   1 reply so far

The part you want to remove is “tapered”. Therefore after tightening screw of puller you must get a large hammer and hit the end of the puller bolt. This will jar the casting off the taper. Make sure the puller is very tight first!