About ericm

image: ericm's picture
Recent content
TitleUpdated
Kluge foil shop closing14 Sep 22
leaving ink on windmill system12 Jun 22
Numbering Machine repair5 Jun 22
Locing up your die cut12 Feb 22
Largest numbering machines29 Jan 22
edge gilding with foil9 May 21
Kluge "No-Name Clutch"11 Feb 20
copper die for printing28 Oct 19
NCIS Los Angles15 Jun 19
mid 70's Triumph Paper Cutter switch23 Feb 19
Recent comments
Title ↑Date
18 Mar
1) is your image centered or a bit low...23 Nov
1) should be stamped on the frame 2)...20 Mar
1) the kluge feeders were added to...9 Mar
1) Universal Engraving: Kansas 2) Metal...20 Sep
1,000-1,200lbs27 Apr
13-19 has new style steel frame, so i...1 Jan
2 big issues here when we talk "nicks"....16 May
2,000 miles... I would buy a capable...30 Jan
240 is a 3 phase current. you would...5 Apr
30 years ago, Mag dies were a...4 Oct
300F is pretty high. i would inverst...1 Apr
324 inches on an 8 1/2 x 5 1/2 sheet?...17 Nov
3in wide plywood will work. Long enough...22 Jul
3m 7xx something? I have used it for...8 Jun
80 bucks (up to about 4" x5") +...21 Feb
? a few more details or questions with...17 Aug
? I don't have a web site...23 Jan
@ Dennis; Are you shutting heat off end...13 Dec
a 12 x 18 kluge/CP would suit your...11 Dec
a 6 x 9 plate wouldn't really need 3...15 Oct
a close up of the control panel would...28 Feb
a few degrees of movement is fine. it...6 Mar
a few things could be checked by...14 Oct
a file will most likely damage the...8 Dec
a fully loaded kluge with both foil and...4 Jun
a gear puller could be tried on this...25 May
a good motor repair shop would likely...10 Dec
a GOOD pair of scissors will cut that...11 Jul
a heat plate system with controller is...1 Feb
a nail won't work. way too soft. you...22 Nov
a new single phase motor will prob cost...17 Jan
a pic would be nice. other wise who...23 Feb
a reference to size would be nice and...31 Jan
a roll 24 in wide by 1,000 ft long is...18 Feb
a sharp narrow chisel tapped into the...3 Dec
A) Those prob are, peened over a bit...9 Mar
A) As stated above, this is Not a...1 Mar
A)the bolt should belong enough to...23 Aug
acetate19 Apr