Adjusting Cutter Blade

I just purchased a Challenge 193 HB paper cutter and I need to adjust/level the blade. Does anyone have instructions or advice on how to do this?

Any help is much appreciated!

Carrie

Log in to reply   2 replies so far

You should start with a new surface on your cutter stick, Adjust the blade to where it does not touch the cutter stick when the blade is in lowest position. Raise the blade and place copy paper (20# bond) sheets under the blade. Use the adjustment screws to lower the blade so that when you cut, the blade just touches the cutter stick and cuts the copy paper. The blade should not gouge or cut into the cutter stick.

Sumner

Thank you so much, Sumner! We sorted it out today and your instructions were very, very helpful.