Heidelberg Windmill Motor Drive Guard
I recently obtained a 10x15 windmill and it is in working condition except I needed to replace the three phase motor with a single phase. I have bought a single phase motor to replace it however I am having great difficulty removing the belt guard from the old motor. The bolts and screws have stripped. I was wondering if I can purchase some sort of belt guard for electric motors that would serve to keep the V-belt in its proper place.
Travis
Need more info to help. Heidelbergs usually run with a flat belt and a variable speed pulley on the motor. If you are using a V-belt then your motor pulley has to line up with the press pulley/flywheel. A BELT GUARD is for safety only and should not touch the belt or it will cause damage.
Mike
I am replacing the motor and the belt guard will not come off the old motor, I was wondering if anyone knows where to buy a similar belt guard, perhaps there is some confusion on what I am calling the belt guard, I am referencing the disc and spring assembly that is literally screwed onto the motor.
Travis
That sounds like the variable speed pulley. They are available through your local electric motor shop or a bearing and gear dealer. Don’t know where you are but here in Canada the nearest city has a pop. of only 70,000 and there are a few places that could help out. Try your yellow pages or wait for more posts on this topic.
Mike
Any chance you still have the 3-phase motor and want to sell it?
Dave