Category: Troubleshooting the press
Later topic: Sigwalt truck size needed
Earlier topic: Windmill Clutch wont engage

oscillating rollers for kluge

Does anyone know where to purchase oscillating rollers for a Kluge 12 x.?

Log in to reply   11 replies so far

Hi,
I may have one. Will check next week & let you know.
Thanks,
Jim

Thanks Jim!
Patrick

Patrick,
I have two osc/rider rollers, for the form rollers. They are in good condition and ready to use. I tested the fit on a 12x at Printers Hall in Mt. Pleasant. That particular press had a homemade modification that limits it to rollers with approx 1/4inch shorter shaft. Because of this I was not able to latch them in on the flywheel side. However, I believe they came from & will fit a 12x Kluge.
I would like to get $100 for the set of two.
Can send pics.
Thanks,
Jim

I would love to have detailed pictures of these roller ends. I would like very much to pursue making a set of replacement rollers for my C&P Craftsman. My email is my user name (-at-) yahoo (dot) com

Thanks
Justin

Hi Jim,
Yes, please send pics of rollers.

Thanks,
Patrick

Patrick,
Pics…
Thanks,
Jim

image: 9 - 20 - 2010 012.jpg

9 - 20 - 2010 012.jpg

image: 9 - 20 - 2010 013.jpg

9 - 20 - 2010 013.jpg

image: 9 - 20 - 2010 011.jpg

9 - 20 - 2010 011.jpg

I’m needing these same rollers. If Patrick passes, I’ll take the set.

Hi Jim,
They look good, tell me payment method you would like.
Patrick

Hi Jim,
I double checked the measurements on my
kluge 12x and my press can only hold a 24.875 osc.roller and the rollers you have are 25.5. They might be for a 14x.
Patrick

I am still interested in the rollers ,I might be able to cut them down to fit.
Patrick

Patrick,
Let me know if you are still interested. If you are, can you use PayPal?
Thanks,
Jim