Removing Windmill frisket holder

I have a project which requires me to load a wider roll of foil than what the press normally allows for. Sliding the left foil holder over further would cause it to hit the frisket bar holder upon impression and bend/break both of them. (I’ve done this already)

Is there any way to remove just the frisket holder part of this? That extra inch is crucial. I’d like to avoid taking an angle grinder to it.

image: image2.JPG

image2.JPG

Log in to reply   1 reply so far

I can use a roll of foil 10” long x 200 feet. Why would you need something bigger? I don’t think you want to mess with the mechanism, it’ all connected to the platen and drive shaft. Maybe you can use a different type of foil holder.