Fixing or Replacing a Broken Horton Clutch

A mechanic was reassembling the 8x12 C&P that I recently purchased, when he accidentally cracked the Horton Clutch. It was a clean break. Looking for a replacement part or, if I can’t find a replacement, the best way to repair. Any insight is appreciated! I’ll add additional photos in the comments.

image: B8016ADF-90E9-4792-BCE6-68AE87F312AD.jpeg


Log in to reply   3 replies so far

Additional photos:

I had a similar break on a Kelsey Press. Welder was able to fix. I can find their method if needed.

A good welder should be able to _braze_ it; much lower heat than welding so it’s easier on castings.