About zbang

image: zbang's picture
  • Member for 7 years 30 weeks.
  • Last access 5 days 19 hours ago.
Recent content
TitleUpdated
Bolt threading on Challange Gordon22 Mar 20
Tympan bails on a Kelsey8 Mar 20
Spider chase?27 Jan 20
Oiling a Challenge Gordon14 Dec 19
Kelsey Excelsior paint color31 May 19
Challange Gordon goes thunk6 Dec 12
Recent comments
TitleDate ↓
Scott- great to hear that. Since the...13 Jun
Scott- A trip to the motor repair...31 May
FWIW, a friend has had decent success...22 May
Good luck getting toluene in some parts...22 May
Did I mention "very carefully" :)...18 May
The hardware stores should be open...17 May
I'd start by posting a classified here...17 May
Depending on how thick the ink film is...11 May
MaynardNews, I was thinking that you...6 May
You could use a drum sander or a...4 May
My method is close enough to Geoffrey's...4 May
The position of the brushes determines...29 Apr
Second that (and I should have...29 Apr
Also check out "The Letter-Press...29 Apr
Is the brush rigging shifting while...29 Apr
Carb cleaner or brake cleaner should do...16 Apr
The Kimble Motor company was absorbed...16 Apr
Assuming the motor doesn't have "grease...15 Apr
Making the bolt isn't much of a...8 Apr
Re motors- Your best option is to...8 Apr
I'm sure a 3-d printed wouldn't last...3 Apr
I did check the thread pitch with a...30 Mar
Looks like a pad counter. Check the...30 Mar
For the best surface, use a drum sander...20 Mar
www.art-boards.com (with a...17 Mar
Definitely peened, wasn't sure if the...9 Mar
If you haven't already, completely...8 Mar
I'd start with a band saw to rough-cut...10 Jan
There's the old tradition of printing...6 Jan
...almost... hand feeding a Challenge...28 Dec
FWIW, a few days ago I did a few small...26 Dec
My method- Wire-brush off as much...25 Dec
Ugh, bags :) Every year we print a job...25 Dec
OK, so there should be an oil hole in...16 Dec
Once I got under the grime, this was...5 Jun
I have great fun showing them to...31 May
Geoffrey, I didn't do that, but will...12 Dec
Thanks inky. I guess I'm looking for...7 Dec