About linegauge

image: linegauge's picture
  • Member for 17 years 11 weeks.
  • Last access 6 years 7 weeks ago.
Recent content
TitleUpdated
Aluminum and resalite furniture17 Apr 20
Anyone need a few Ludlows and a ton of mats?28 Feb 18
Schmidt Graphic Equipment, Inc.10 Nov 14
Dried and stubborn ink remover14 Mar 11
Watch the classified ads26 May 10
Furniture5 May 09
Backup plates?5 May 09
Recent comments
TitleDate ↓
Sounds like a chase fell out or...6 Jul
You are either over packed or the...4 Jul
Windmills are meant to be leveled at...10 Mar
Try adjusting the top and bottom...28 Feb
Just waiting for this bubble to pop...28 Feb
You need to run a small amount of type...28 Feb
Recycle them. Remove any of the other...23 Nov
No reason for it to heat up at all. Be...14 Aug
Look on the motor. The plate should...14 Aug
Does the clutch "grab" when you engage...6 Jul
For the ink disk and any other place...26 Jun
Check out Rudow, the sucker people at...1 Jun
When the gripper bar is at the 6...28 May
Disconnect the oil pipe exiting the...27 May
One more suggestion, have a mechanic...27 May
It is gear backlash from not oiling the...17 May
See if there is an oil pump on the back...14 May
Should be inside the electrical door on...10 May
Have the machinist make a new shaft and...10 May
You would be better served widening the...4 May
I have several customers that use them...8 Mar
You must have a very dry bearing in the...8 Mar
Are you talking about the impression...2 Mar
Hey Fabio, still at it? Replace the...20 Feb
I suggest that if you are going to...5 Jan
He sends the dies back to the die-maker...4 Jan
Can't get them that I know of. If they...4 Jan
You need to take the flywheel to a...4 Jan
I have a customer here in the US that...4 Jan
Pamarco here in Atlanta just made a set...13 Dec
When I install Windmills, I use thin...6 Dec
If the growl changes pitch or volume...19 Nov
Acid based paper never gave much of a...12 Nov
Buying printing is like buying oats. If...12 Nov
AA die in Atlanta does laser...12 Nov
"Some motors are dual voltage. You have...11 Nov
As a mechanic, the Miehle is a great...10 Nov
I have been printing and servicing...7 Nov
That stuff is part of an old Kluge Head...7 Nov
Disconnect the motor from the hydraulic...4 Nov