Category: General discussion
Later topic: Brausse 40 inch diecutter
Earlier topic: APHA Call for Papers – Wayzgoose 2020

Where to inflate the rubber

Hi All,

Can anyone point me to someone who can inflate these to their correct size to be used on a 10 x 15 C&P. I had them recovered and the business was supposed to get back to me about inflation but I haven’t heard back! Thanks in advance.

image: IMG_5469.JPG

IMG_5469.JPG

Log in to reply   3 replies so far

  • ericm
  • on 19 Mar 20 (00:55)
  • Updated 19 Mar 20 (04:16)

i think you screw the side plates together to expand the rubber due to “crush” from the plates.

Yep, tighten the bolt

if you have a old core lock it in a vise then crank it down you need to get to 1.75 inch. I am going to start making new ones a little taller to make adjustment easier.