Kelsey Hand Press 6” by 10” comes with 1 chase….needs rollers and trucks Asking $400.
H.B. Rouse Lead Slug Cutter Asking $60.
Round corner machine... more
I’m looking for a font of University of California Old Style w/discretionary ligatures (ct, st, aw, oe) in 12, 14 or 16 point, both regular and italic.
M&H has the... more
I seem to recall that recently (i.e. the past two years or so) someone was making chases for Sigwalt Chicago No.11 presses, but now I can’t find anything about this.... more
For Sale
Book Press-top plate measures 15” wide by 10” deep by 3” high for book. Unknown brand or date? Price $250.
Lock-up Stone-3 feet wide by 2 feet... more
A set of Ludlow mats, unidentified font
This font has a serif and I think it’s bold (?) but I don’t know its name.
Sorry for the lousy pictures, these... more
It has been a fun, educational, and rewarding run of fifteen years learning letterpress! However, I’m selling my garage full of equipment.
Highlights include a 1954... more
C&P press motorized, plus whole working printshop. $15,000 you ship. Type, cabinets, paper cutter. Fits in single car garage. Email for detailed inventories.
more
Hello! I am a printmaker and letterpress studio in Toronto and am looking for a vandercook or challenge-type flat bed proof press. If you happen to have one kicking around (a real... more
Im looking for a table top or floor model Rosback (or similar) perforator. I know you can get perforating rule but I like the look of the pin perforation. Im located in Canada, so... more
A beautiful selection of diecut Victorian style fancy blank cards made with 110lb heavycard stock. Available in white, cream or kraft brown colour. Classic Victorian calling cards... more
The Kelsey is in excellent condition and fully functional. It is attached to the wooden table. The Nolan Proof Press needs to be assembled (all the pieces are there). I am... more
V-50 Miehle Vertical & Type Case
- last used 2009-2010? [not set up to print]
- I purchased it in 2010
- it was used in Peterborough - I bought it in Georgetown... more
I had 2 custom parts made for my vandercook 4 then I found them (they were hiding in a box of screws and oddly shaped parts from the previous owner). These parts are ms-276 lift... more
Hello, I have for sale a 1965 Redball Windmill for sale. Excellent printing condition with newer rubber rollers, and very good registration. Lots of new tympan sheets, boxcar... more
Im looking for a drive chain for a vandercook 4. In the parts catalogue ist is ‘mm-126’ any pictures or info on this area of the machine would be appreciated too!
more
