About Bruce cpd

image: Bruce cpd's picture
Recent content
TitleUpdated
subject to tariffs5 Jul 18
kluge rider roller adjustment10 Aug 16
truck wear10 Jun 15
9/16 inch bearings16 Jul 14
compression springs3 Feb 14
Kluge rider roller26 Jul 13
gripper timing28 Jun 13
Recent comments
TitleDate ↓
I have some brass extension guides...13 Dec
This isn’t an actual setup but I put...12 Dec
I’m in Maryland, USA. We have two 12...11 Dec
If I owned a .853 base which uses .059...14 Nov
I posted the question after reading...25 Sep
You might try wrapping the treadle hook...19 Sep
so looking at photo 6135, there is...19 Sep
I appreciate your comments about the...14 Aug
Regarding this statement; "I’ll take...13 Aug
I forgot to mention above that the...10 Aug
Hi scottbaldwin, We have three basic...10 Aug
Hi daleraby, Your post has me confused....9 Jul
Talk to; Toland & Son Saw & Knife...15 Jun
When you took the rollers off did you...2 May
Have several kluges, models N and NA...23 Mar
I mount polymer plates on MDF or 3/4"...20 Mar
I saw a video of this press running...12 Mar
don't know what packing you use for...7 Mar
Possible solution for this issue; place...5 Mar
What's on them? If it's dried ink then...20 Feb
As mentioned above, for getting good...19 Feb
At the begining of your post it sounded...13 Feb
If you can obtain the instruction sheet...26 Jan
Hi Amanda, I'm not sure from your...15 Jan
When I see the first print inks well...7 Dec
Ok the test doesn't tell if the bed or...27 Nov
Hi pressink.sk, There is a way that...27 Nov
Seems odd that if everything was vector...17 Nov
The jagged lines may well come from the...17 Nov
I used a camera for years and though I...14 Nov
There are always different points of...31 Oct
On occasion I have used an epoxy called...23 Oct
If you haven't already done this, I...11 Oct
I recently found out that the piece...28 Sep
Hi gutenberg99, back in the day the...26 Sep
This may be out in left field somewhere...25 Sep
Hey Frederik, Your polymer comes with...14 Sep
First examine the clean plate in good...28 Aug
Hi Marcieb, If yours is a 12 x 18, I...17 Aug
Hi 1crem1, another important point when...28 Jul