About parallel_imp

image: parallel_imp's picture
Recent content
TitleUpdated
deleted when left pending for two years23 Apr 15
Recent comments
TitleDate ↓
And note that a capacitor can hold a...7 Dec
The tail deadline on the 320/325 shows...21 Nov
The Sigwalts I've seen all have pins...12 Nov
...and M&H Type and Skyline Type each...11 Nov
Not a Tiegel-Heidelberger, but I...7 Nov
The lower bearings are set to prevent...3 Nov
The bearings under the rails are the...30 Oct
Miraclon is not the same line it was...23 Oct
I second that. Rubber blanket gives a...11 Oct
If rails are taken very low, changing...10 Oct
Sorry if my jig suggestion was not...9 Oct
Since wood type is made to pica lines...8 Oct
This excellent website will provide...7 Oct
There IS a carpenter's solution to the...3 Oct
I'd recommend getting a set of metal...3 Oct
Grendl, with SPs, the upper carriage...27 Sep
As I recall it, the Hacker test press...29 Aug
Go to...8 Aug
My guess is a Wesel base. The Warnock...27 Jul
Gane Brothers & Lane was the...14 Jul
Looks like ATF Alpha Blox or something...12 Jul
I think the sheet is fed face-down...12 Jul
I think it is around .021". There is an...12 Jul
There are rotary miterers, this might...14 Jun
That's M&H. Quaints were not available...26 May
I think that would be a taper key with...19 May
Sounds and looks Italian...I would...13 May
Suburban French, Lanston Monotype 172....7 May
I've only examined a Golding Jobber...3 May
The rod for the batter gauge is...20 Apr
The batter gauge is used with the...17 Apr
If you've removed the L-bracket...7 Apr
M&H has 12 and 18 point tie-up strip...29 Mar
On BriarPress, you can't upload pics...24 Mar
Haven't had a C&P in many years, but as...21 Mar
It's called a bias chase.8 Mar
Bare magnets aren't normally used as...8 Mar
Third, is the form type-high? You might...5 Mar
Consider carriage bolts inserted from...27 Feb
Since the press is screwed into a base...27 Feb