About phase4

image: phase4's picture
  • redrog
  • emil kahle zeus automat and heidelberg windmill 10x15
  • Uruguay
Recent content
TitleUpdated
heidelberg windmill stopped sucking after 2000...22 Mar 15
Embossing23 Feb 15
Embossing23 Feb 15
recommendation8 Dec 14
motor on emil kahle letterpress26 Nov 14
numbering software11 Aug 14
press identification14 Dec 10
emil kahle zeus automat13 Dec 10
Recent comments
TitleDate ↑
photo before cleaning13 Dec
another picture14 Dec
and one more. the tympan size is 30x...14 Dec
thank you for your information. when...14 Dec
thank you i did find a very blury jpg...15 Dec
hi again i was looking at the flyer and...20 Dec
hi the pantones are very easy to mix...13 Apr
go for sandvik steelrules8 Apr
.28 Aug
you should havea new cutting stick you...10 Sep
use turtle wax and steelwool should...10 Sep
and for the pressbody kerosene 10 Sep
4 surfaces are available on polar...12 Sep
jag har set nagra pa blocket for en tid...12 Sep
There was a Fórmula used for the...4 Oct
Pienso Que con tinta Amarilla Te va...11 Nov
check the valves on the pump should be...28 Nov
also check that the air filters are...28 Nov
just put a rubber band and its fixed28 Nov
you can also search for a grafopress...26 Dec
it prints on all kind of papers now a...8 Jan
Silver ink works with black stock and...9 Jan
If your on tight budget u can get cyan...11 Jan
First you need to convert your image to...10 Mar
This commercial is...12 Mar
Hi i would recomend doing a test drive...20 Mar
you can mark a sheet when it is grabbed...21 Mar
you can mark a sheet when it is grabbed...21 Mar
I believe that the different...26 Mar
At this point were you allready have...28 Mar
You could try to varnish them 10 Apr
the rollers for uv are different but it...11 Jun
maybe its easier just to screenprint...11 Jun
Yes you will need different type of...12 Jun
In this case you will not need to...12 Jun
You could also use type high wood base...12 Jun
You can also tape a steelrule to the...25 Jun
In this case you woul use low high perf...25 Jun
:-) 25 Jun
Hi you need to do the adjustments with...14 Jul