About AnonyMouse

image: AnonyMouse's picture
  • Member for 13 years 14 weeks.
  • Last access 2 years 21 weeks ago.
Recent content
TitleUpdated
Windmill motor - 1ph, 220V14 Apr 16
VFD for a Windmill?14 Apr 16
Sanderson's type recovered from the River Thames20 Feb 15
CAD drawings of hard to find chases5 Mar 14
Missing page in the common 10x15 parts book13 Feb 14
Windmill register spindle - binding 26 Jul 13
Recent comments
TitleDate ↓
I've ground the small end of the pin...30 Nov
You may find on some C&Ps that there is...4 Sep
I'd call some local industrial...30 Apr
If the grippers have not been swapped...27 Apr
You could test this:21 Apr
I tend to agree, Mic... An...2 Apr
Youtube videos can be played at .25...11 Mar
Looks like all you need is the large...5 Mar
Sounds pretty good, even listening with...19 Dec
First, I'd unplug the machine and...16 Dec
A couple of thoughts... I'd try a...26 Oct
Are those metal shavings on cog? Where...19 May
Hi and thank you for the info. I'll...14 Apr
WRT no way to tell before the second...25 Nov
If it is being pushed rightward into...25 Nov
I'd ensure the the bearings in the...17 Nov
Owasso's work has been generally very...14 Nov
I wouldn't give the public too much...6 Nov
I would try gripping the 5.5 edge....3 Oct
I'd probably run the ramp turned as far...8 Sep
A couple of thoughts: If the bite is...7 Sep
Further thoughts: If the press also...6 Sep
How much "bite" do the grippers get on...6 Sep
The pics look like the end of the...5 Sep
Hi May, I'd check the trip pawl and...3 Sep
Hopefully we are discussing the same...1 Sep
Most likely a bent spindle. It is...31 Aug
I'd check for free movement with the...29 Aug
Never mind, read the problem poorly. As...6 Aug
Another method of bending with...5 Aug
As I recall, the adjustment screws are...4 Aug
There is one grease point, as I...3 Aug
Oil is cheap. I'd oil weekly...2 Aug
There is a lever on the right side of...22 Jul
Are you spinning the flywheel by hand...16 Jul
Are you spinning the flywheel by hand...16 Jul
I advise against the leap to the...8 Jul
I'll respectfully add that when...25 Jun
Only seeing this topic today... didn't...13 May
First, I'd check that the press is...10 May