About sylvia c

image: sylvia c's picture
Recent content
Windmill Roller Problem3 Jul 19
Any tips for more vibrant colors on small type?25 Apr 19
Photopolymer Plate Longevity8 Mar 18
Windmill pump making unusual noise7 Dec 17
Dave Robison (Ink in Tubes)26 Mar 16
No. of parts for Pantone Warm Grey 9 ?21 Jan 16
Windmill diecutting, paper scraps22 Aug 15
Windmill weekly lubrication question1 Aug 15
Windmill Paper Guide for Small Sheets (bus. cards)24 Mar 15
Windmill Rider Roller30 Oct 13
Recent comments
TitleDate ↓
letterpress standard, I will check the...9 Jul
jhenry, Before putting the bearings and...7 Jul
mick, thanks for all your comments. I...6 Jul
I'm fairly certain they are the same...5 Jul
No I'm not running without the bearing...4 Jul
HavenPress, I use both Van Son & Ink...27 Apr
Hi Frank, Thanks for your response....26 Apr
Thanks HavenPress this is really...26 Apr
Hi J Russell & Colophon, I do use a...26 Apr
Hi Frank, Yes I can match a small...25 Apr
gachap, could you post the address of...7 Oct
Thank you gachap & foothillpress for...7 Sep
I am so concerned to hear this news...16 Jul
A very good source...12 Apr
I recently had a problem where inking...15 Mar
Thanks, I will investigate.9 Dec
Thanks Pete, I will email you.31 Mar
As I said, I've had very good...30 Mar
It's difficult to imagine that in 8...27 Mar
Just wanted to come back and say that I...10 Feb
Thank you very much Geoffrey-- I was...21 Jan
I am new to die cutting. I do think my...24 Aug
kellypress, Thanks, this sounds like a...22 Aug
Thanks for the advice everyone. I've...2 Aug
Matt, The space is approx. 12 x 12...23 Jul
Yes I have a studio space built into...23 Jul
To be more specific, they are referred...24 Mar
Thank you very much for the comments. I...30 Oct
Thank you! I'm aware of some of these...9 Aug
I do have the manual, I'll take a look....15 Dec
Daniel, Do you happen to have a link...15 Dec
Daniel, Yes it's an SP-15. It doesn't...15 Dec
Thank you all for your comments on this...14 May