About Watne

image: Watne's picture
  • Member for 18 years 30 weeks.
  • Last access 6 years 40 weeks ago.
Recent content
TitleUpdated
Heidelberg central oiling question13 Jun 16
13x18 Heidelberg windmill - clack valve cam/roller3 Nov 14
Feed board dimensions for C&P25 Sep 09
Recent comments
TitleDate ↑
You are looking for 19H suckers (flat...7 Dec
We use Mobilgear 600 XP150. It is a...2 Nov
There are two pairs of holes, towards...25 Jun
From a Letpress message from Hal...26 Sep
I usually run business cards two-up on...27 Sep
Actually the lockout feature came in...13 Oct
Barker - bingo! That's how I do it....26 Nov
Not sure of the total capacity, but it...4 Jun
With some practice you can switch...27 Jun
Most importantly, these threaded pins...15 Jun
I would imagine any current grease...25 Oct
I've found that redoing the rubber in...28 Oct
Naphtha is the main ingredient in many...9 Nov
I also would recommend two hits if you...9 Nov
I would use only one left-hand pin....6 Feb
I've had some luck using a hand plane...31 May
Nick, big thanks for this! Lots of info...31 Aug
The key issue to me is that the...21 Sep
Well, never mind! For the record, the...3 Nov