About PaulM

image: PaulM's picture
Recent content
TitleUpdated
Pearl #1 ?22 May 17
double post sorry30 Nov 15
Morgan Line O Scribe30 Nov 15
build date for challenge tabletop proof press3 Apr 15
are treadle shafts symetrical?28 Feb 14
V-50 cylinder will not go off impression22 Oct 13
Motor mount bushing for Hammond Type saw16 Jan 13
PMS 7712 formula11 Oct 12
Windmill for sale: Atlanta22 May 12
Does anybody have a 10x15 Parts press?16 Aug 11
Recent comments
Title ↓Date
You can still buy letterpress inks but...14 May
Yes, you can clean them with kerosene...2 May
Where in VA are you. I am in the...23 May
when you cut the stock always be sure...3 Jun
when printing with four deckle edges I...4 Mar
When planning your cuts allow a little...23 Mar
When I am not using my pony fountain I...16 Sep
when adjusting the platen on my 8x12 I...21 Feb
What model is it, i am also trying to...1 Jun
went for around 125. Some body got a...21 Oct
We use Owasso graphic at...30 Sep
We use bowling alley wax and only have...9 Apr
We strip our by hand and save the...10 Oct
we have run lettra envelopes and 300...24 Oct
We have a Babcock Optimus handfeed...14 Mar
We are in Richmond, VA, The only steam...19 Mar
Tuff tex is from van son and works...1 Nov
try searching for printing press and...5 Aug
Try a #4 in the center of the sheet and...7 Aug
Try washing everything down again and...14 Apr
this pedal will raise the cylinder....6 Feb
The weight of the combination should...18 Nov
The pin is disengaging so it will go...23 Oct
The Motor in front of the press may be...29 Sep
the imposing stone I work on is an old...29 Mar
The high spots are probably from when...6 Dec
The high spots are probably from when...6 Dec
The bottom pieces look very similar to...25 Sep
The amount of packing will also vary...17 Feb
Thanks, you are awesome. 11 Oct
Thank you all for helping to confirm my...28 Feb
Something else to consider is, that if...3 Aug
Remember, there is no piece of paper or...27 Apr
printertim, I have had the same...20 May
Panthera, We are in Richmond, Va...4 Jan
oops, my spell check must be...30 Sep
On the grippers, For short term and...11 Feb
On soft stock if you clamp too hard it...12 Aug
mrs chin press, I work in...19 Jan
matt, you will need a steel...31 Aug